Connecting a Wi-Fi Display to Your Wi-Fi Service

Follow

If your display unit has the Wi-Fi capability to stream its data to Weather Underground, the following procedure can be used to set up this connection. Please follow the steps carefully as the order is crucial to the success of the Wi-Fi setup.

Before you begin:

  • Pair the sensor and the display per the manual's instruction. Confirm the display is maintaining 4 bars of signal strength and is receiving current data.
  • Make sure DHCP is enabled on your router. Most routers have DHCP enabled by default.
  • Ensure your router is broadcasting a 2.4 GHz network. The weather station display is equipped with a Wi-Fi module that only supports 2.4 GHz wireless networks.
  • Have your Wi-Fi network's SSID (name) and Password ready. These are case sensitive.
  • Create an account on WUnderground.com and Add New Device. Select the correct device hardware under Personal Weather Station then enter the requested information. Once your station is created you will be provided with a Station ID and Station Key. Have these ready and keep in mind that these are also case sensitive. 

        • Look carefully to differentiate “3”, “B”, and “8”. If you’re not sure, try the alternatives.
        • Look carefully to differentiate “D”, "O", and “0”. If you’re not sure, try the alternatives.
        • Look carefully to differentiate “I”, "l", and “1”. If you’re not sure, try the alternatives

  • Lastly, open an internet browser and type 192.168.4.1 in the URL - DO NOT PRESS ENTER  mceclip3.png

 

To connect your display to your Wi-Fi:

  1. From a computer, (you can use a smartphone or tablet but this works best from a laptop or desktop computer), open the network tab and click on the AcuRite Wi-Fi Display Model Number.

    mceclip2.png

    NOTE: If you do not see the display model under your network tab, please reset the display by pressing and holding the RESET button for 10 seconds, located in the battery compartment of the display. The date and time will need to be entered after a reset.

  2. Click the box to connect automatically. Press the connect button for the network that includes the Display Model Number. 

    mceclip0.png

    NOTE: This will disconnect your computer/device from your internet and the display's network may also say No Internet.

  3. After 20 seconds, go back to that prepared browser that has 192.168.4.1 typed in the URL and press enter.

    mceclip3.png

  4. Once the AcuRite Wi-Fi display settings website (splash page) is open, select your Wi-Fi network's SSID from the dropdown (if you have a 2G and a 5G, be sure to select the 2G), enter your Password, Station ID, and Station Key, then click save.

    mceclip0.png

    NOTE: If you are unable to open the AcuRite Wi-Fi display settings website after connecting to the display, disconnect from the display under the network tab, open a different internet browser, enter The IP address 192.168.4.1 into the URL but DO NOT PRESS ENTER. Connect to the display under the network tab and wait 20 seconds before clicking enter on the internet browser with the IP address entered. 

 

 

*If your display unit is Model #01544M or #06100M, please use the steps in the following link instead:

Direct to Wi-Fi 5-in-1 Weather Station Setup

A video tutorial is included in this link that you may find helpful even if you do not have the listed model.

 

If you are still experiencing concerns, please contact our U.S. based support staff by Submitting a Request or by chatting with our Live Agents. If you already have an open ticket with a support agent, please reply to the last email sent. If you were able to get to the splash page, please provide a screenshot of the splash page with your information entered.

 

Was this article helpful?
6 out of 100 found this helpful