If your display unit has the capability of adding additional sensors other than the AcuRite Iris® (5-in-1) sensor, but the display is unable to connect to the additional sensor or sensors, follow the steps below.

Display model 06046/02080/01022 - Lightning Detector model 06045 is required to connect two additional sensors: models 00592TXR/06002M and/or 06044M.

1. Reset the display by pressing and holding the RESET button in the display's battery compartment for 10 full seconds. Time and date will need to be entered after a reset.
2. Make sure that the AcuRite Iris® (5-in-1) sensor is connected to the display first.
3. Set the lightning detector to the same channel as the AcuRite Iris® (5-in-1) sensor. Once the AcuRite Iris® (5-in-1) sensor is paired, the display will begin to search for the lightning detector.
4. Verify that the additional sensors are set to the remaining two channels. Once the lightning detector is paired, the display will search for the other sensors.
5.  Confirm the sensor is powered on with a reading on the display (model 06044M) or has the red light flash every 16 seconds (06002M).

Toggle between indoor readings and each sensor’s readings by pressing and releasing the down arrow button. In auto-cycle mode, the display will automatically cycle through indoor and each sensor’s data. The auto-cycle mode can be activated by pressing and releasing the down arrow button until the semi-circle icon appears to the right of the house image.

Display model 06056/01536 - Compatible with up to three sensors: models 00592TXR/06002M and/or 06044M.

1. Reset the display by pressing and holding the CLEAR RECORD / RESET button for 10 seconds, located in the battery compartment of the display. The date and time will need to be entered after a reset.
2. Make sure that the AcuRite Iris® (5-in-1) sensor is connected to the display first.
3. Verify that the additional sensors are set to different A-B-C channels.
4. Confirm the sensor is powered on with a reading on the display (model 06044M)  or has the red light flash every 16 seconds (06002M).

Toggle between indoor readings and each sensor’s readings by pressing and releasing the up or down arrow buttons. In auto-cycle mode, the display will automatically cycle through indoor and each sensor’s data. The auto-cycle mode can be activated by pressing and releasing the up or down arrow buttons until the semi-circle icon appears beneath the indoor temperature.

If you are still experiencing concerns, please contact our U.S. based support staff by Submitting a Request or by chatting with our Live Agents. If you already have an open ticket with a support agent, please reply to the last email sent.