Additional Sensors Not Connecting to 5-in-1 Display

Follow

If your display unit has the capability of adding additional sensors other than to the 5-in-1 sensor but the display is unable to connect to the additional sensor or sensors, follow the steps below.

 

Display model 06046/02080/01022 - Lightning Detector model 06045 is required to connect two additional sensors models 00592TXR/06002M and 06044M.

  1. Reset the display by pressing and holding the RESET button, located in the battery compartment of the display for 10 full seconds. Time and date will need to be entered after a reset.
  2. Make sure that the 5-in-1 sensor is connected to the display first.
  3. Set the lightning detector to the same channel that the 5-in-1 sensor is set to. Once the 5-in-1 sensor is paired, the display will begin to search for the lightning detector.
  4. Verify the additional sensors are set to the other two channels that are left. Once the lightning detector is paired, the display will search for the other sensors.
  5.  Confirm the sensor is powered on with a reading on the display (model 06044M)  or having the red light flash every 16 seconds (06002M).

Toggle between indoor readings and each sensor’s readings by pressing and releasing the up or down arrow button. In auto-cycle mode, the display will automatically cycle through indoor and each sensor’s data. The auto-cycle mode can be activated by pressing and releasing the up or down arrow button until the semi-circle icon appears to the right of the image of a house.

 

Display model 06056/01536 - Compatible with up to three sensors models 00592TXR/06002M and 06044M.

  1. Reset the display by pressing and holding the CLEAR RECORD / RESET button for 10 seconds, located in the battery compartment of the display. The date and time will need to be entered after a reset.
  2. Make sure that the 5-in-1 sensor is connected to the display first.
  3. Verify the additional sensors are set to different A-B-C channels.
  4. Confirm the sensor is powered on with a reading on the display (model 06044M)  or having the red light flash every 16 seconds (06002M)

Toggle between indoor readings and each sensor’s readings by pressing and releasing the up or down arrow buttons. In auto-cycle mode, the display will automatically cycle through indoor and each sensor’s data. The auto-cycle mode can be activated by pressing and releasing the up or down arrow buttons until the semi-circle icon appears beneath the indoor temperature.

 

If you are still experiencing concerns, please contact our U.S. based support staff by Submitting a Request or by chatting with our Live Agents. If you already have an open ticket with a support agent, please reply to the last email sent. 

Was this article helpful?
5 out of 57 found this helpful