Replace an AcuRite Access or PC Connect Display Connection

Follow

When you replace an AcuRite Access or PC Connect Display, its linked sensors are transferred to the new device.

Before you begin

AcuRite Access - be sure it's powered on and connected to your network (Internet) router. At a minimum, be sure there is one AcuRite sensor in wireless range of the AcuRite Access.

PC Connect Display - verify the Indoor Display is connected to your computer, the computer is on and has an Internet connection, and My AcuRite Sharing is enabled from the PC Connect software.

Open PC Connect 2.0.4 Software to confirm under Status shows the following: pc_connect.png

MyAcuRite.com: How to replace an AcuRite Access or PC Connect Display

  1. From the menu, select Settings > Devices.

  2. From the AcuRite Access or PC Connect Display you are replacing, select ic_settings_backup_restore_black_24px.svgReplace.

  3. Enter the 12-character Device ID of the new device.

  4. Select Save to replace the device.

AcuRite app: How to replace an AcuRite Access or PC Connect Display

  1. From the tab/navigation bar, select ic_settings_black_24px.svg (Settings menu).

  2. Select Manage Devices.

  3. Select the device name.

  4. Select the ic_settings_black_24px.svg icon located in the Device Profile area.

  5. From the upper right corner, select the mceclip0.png icon.

  6. Select Replace Device.

  7. Enter the 12-character Device ID of the new device.

  8. Select Replace.

 
 
Was this article helpful?
0 out of 5 found this helpful