When you replace an AcuRite Access®, PC Connect Display, or Direct to Wi-Fi Display (Connection Device) its linked sensors are transferred to the new device. If you purchase a new Connection Device to replace your existing Connection Device but wish to monitor the same sensor(s), use the replace option.
AcuRite Access - be sure it's powered on and connected to your network (Internet) router. At a minimum, be sure there is one AcuRite sensor in wireless range of the AcuRite Access®.
PC Connect Display - verify the Indoor Display is paired with your Iris® (5-in-1) sensor and connected to your computer, the computer is on and has an Internet connection, and My AcuRite® Sharing is enabled from the PC Connect software.
Open PC Connect 2.0.4 Software to confirm under Status shows the following:
Direct to Wi-Fi Display - verify the Indoor Display is paired with your Iris® (5-in-1) or Atlas® sensor and connected to your Wi-Fi network.
MyAcuRite.com: How to replace a Connection Device
From the menu, select Settings > Devices.
From the Connection Device you are replacing, select Replace.
Enter the 12-character Device ID of the new device.
Select Save to replace the device.