How to Add Access to My AcuRite

Follow
  1. Go to www.MyAcuRite.com and create an account and follow the prompts on the site.

If you have already created an account: 

  1. Click on "Settings" in the upper right-hand corner.
  2. Select Devices from the drop-down menu. 
  3. Below the Display Units section, you will see a section labeled Connections. 
  4. Click on the blue "Add" button to the right of Connections. This will open the Device Profile dialogue box. 
  5. Enter a Device Name.  This can be whatever you would like to name the Access.  I.E. Home
  6. Enter your Device ID that is located on the bottom of the Access unit.  When entering the device ID, keep in mind the following:
    1. "0" is always zero, and never the letter. 
    2. Look carefully to differentiate "3", "B" and "8".  If you are not sure, try the alternatives. 
    3. Look carefully to differentiate between "D" and "0".  If you are not sure, try the other. 
  7. Select your country.
  8. Enter your postal code. 
  9. Click the green "Next" button in the upper right-hand corner of the Device Profile box.
  10. Enter your address information for where the device is located.
  11. Select which way you wish to view your barometric pressure.
    1. Station pressure: Your raw barometric pressure, which can be calibrated.
    2. Adjusted pressure:  Your raw barometric pressure, which is adjusted based off of your altitude. 
  12. Click the green "Save" button in the upper right-hand corner.
  13. Once saved, scroll to the bottom of the screen to Available Sensors and add your sensors.
Was this article helpful?
0 out of 1 found this helpful