No Outdoor Temperature Reading for Model 606TX/06009RMA1

Follow

First, you want to verify the model number of your outdoor sensor. The model number is located on the back of the sensor. If your model number is different than reference the troubleshooting for your particular model.

If the outdoor temperature is showing dashes or not changing the units may have lost connection or are experiencing interference.

  1. Relocate the display unit and/or the outdoor sensor. Under optimal conditions, the units can be located up to 165 ft (50 m) of each other.
  2. Units should be placed at least 3 feet (.9 m) away from electronics that may interfere with the wireless communication (such as TVs, microwaves, computers, etc).
  3. Use standard alkaline batteries (or lithium batteries in the sensor when the temperature is below -4ºF/-20ºC). Do not use heavy duty or rechargeable batteries. NOTE: It may take approximately 5 minutes for the display unit and sensor to synchronize after batteries are replaced.

Synchronize the units:

  1. Bring both the sensor and display unit together and power down by removing at least one battery from each.
  2. Reinstall the battery in the outdoor sensor.
  3. Once the batteries are inserted you should see the red LED light blink approx. every 30 seconds on the front of the sensor.  The red LED light should NOT stay on continuously. 
  4. Reinstall battery and/or power cord into the display unit.
  5. Let the units sit within a couple feet of each other for approximately 5 minutes or until you see a solid sensor signal.
Was this article helpful?
0 out of 3 found this helpful