Monitor Temperature is Flashing or Showing Dashes

Follow
  1. Remove the affected Location from the display.
    1. Press and release the color-coded button next to the location you want to delete from the display.

    2. Press and release the “cog” icon button.

    3. Press and release the “▲“ or “▼“ buttons until “DELETE” is showing.

    4. Press and release the “SET” button. “DELETE MONITOR” will flash.

    5. Press and release the “SET” button to remove the location from the display.

  2. Remove batteries from the remote sensor/monitor only. Do not power down the digital display.
  3. Wait 1 minute.
  4. Reinstall the batteries in the remote sensor/monitor.
  5. Re-sync the monitor or sensor to the previously deleted location on the digital display.
    1. Press and release the color-coded button next to the location on the display. “ADD  MONITOR” will flash at the top of the location.
    2. Press the “SET” button. “SELECT MONITOR STYLE” and icons will flash on the display.
    3. Press and release the “▲“ or “▼“ buttons to highlight the icon that represents the type of product you are adding.
    4. Press the “SET” button to confirm your selection. “SELECT ID” appears on the display.
    5. Press and release the “▲“ or “▼“ buttons to locate the Monitor or Sensor being re-synced.
    6. Press the “SET” button to confirm your selection. “SELECT NAME” appears on the display.
    7. Press and release the “▲“ or “▼“ buttons to cycle through and select the most appropriate available location name. 
    8. Press the “SET” button to confirm your selection.
  6. Let units sit within a couple feet of each other for 2 minutes to ensure a wireless signal is received.
  7. After a connection has been established you may place the sensor in the location you wish to monitor. *If the signal connection fails after the units are separated try a new location for the display unit, the sensor or both.
Was this article helpful?
0 out of 1 found this helpful