Pager Reads "Out of Range" or Will Not Connect


If the pager reads "Out of Range" or will not connect:  

  1. Place both the pager and main unit side by side.
  2. Turn both units off. 
  3. Remove the batteries from both units for 10 - 15 minutes. 
  4. Place the batteries back in the main unit first. 
  5. Turn the main unit ON. 
  6. Place the batteries into the pager.  
  7. Turn the pager ON. 
  8. Leave both units side by side for approximately 5 minutes to reconnect. 
  9. If the unit is still reading "Out of Range" after these steps, replace the unit.
Was this article helpful?
4 out of 14 found this helpful