Week's History Too General

  • 1
  • Problem
  • Updated 2 years ago
I have started looking at the weekly data for my basement temperature/humidity sensor on my laptop using the MyAcurite page. This is a new sensor so there has not been a weekly history until recently.

What I had hoped to see was the trending of temperature/humidity during the day and be able to see values on an hourly basis by moving my mouse along the trace. 

What it seems to be showing is high and low values for the day and no hourly records. 
Photo of pendetim

pendetim

  • 46 Posts
  • 4 Reply Likes

Posted 2 years ago

  • 1
Photo of Chris Dalrymple

Chris Dalrymple

  • 21 Posts
  • 1 Reply Like
I have noticed the same issue. I don't want to see the high and the low points on a daily basis. I want to see the trend lines. 
Photo of George D. Nincehelser

George D. Nincehelser

  • 6747 Posts
  • 1249 Reply Likes
You should get more detailed data if you graph over 3 days (use the "custom" time period) rather than a week at a time.
Photo of Chris Dalrymple

Chris Dalrymple

  • 21 Posts
  • 1 Reply Like
Once I set a custom time period longer than TWO days, things go to daily highs and lows.
Photo of AcuRite Jennifer

AcuRite Jennifer

  • 11801 Posts
  • 536 Reply Likes
Hello All,

When charting up to 24 hours it will show 5 minute intervals. If you chart up to 3 days it will show 15 minute intervals, and if you chart 4-31 days it will show 1 reading per day with the high and lows. Thank you. Have a good day!