RFI not good.

  • 1
  • Problem
  • Updated 7 months ago
  • (Edited)
In my ham radio room stray RFI gets into my 00600 station with 5-1 weather monitor . It causes the touch light to malfunction and all the controls to malfunction. The settings button turns the light on and off. Once in this condition you have to remove power and reset the station thereby starting the self calibration all over again. Had to move it away from the equipment thereby rendering it impossible to connect it to the computer. I put ferrite cores on all the cables and that helped but eventually it still fell victim; as I was transmitting I looked over and the display light was going on and off as I talked sad but I suppose it was just not designed to work in this environment. Love this weather station beautiful little setup.
Photo of Bruce Weight

Bruce Weight

  • 10 Posts
  • 0 Reply Likes
  • Sad

Posted 7 months ago

  • 1
Photo of Fred Flinstone

Fred Flinstone

  • 281 Posts
  • 40 Reply Likes
can't you just move it to another room where there will be less radio interference?
Photo of AcuRite Jennifer

AcuRite Jennifer

  • 11801 Posts
  • 536 Reply Likes
Hello Bruce,

If you continue to get interference we would do as Fred suggested and move it to a different room if you are able to. There is a lot of equipment in that room that is probably causing the display to go haywire. It may be difficult getting it to work correctly in that specific room.