Rainfall Discrepancy between Display, MyAcurite and WU

  • 1
  • Problem
  • Updated 5 months ago

I recently replaced my 5-in-1 Pro Model 06014. Before installing it, I did a rain calibration. I have a Model 060168RM display and an Internet Bridge.  The old 5-in-1 sensor is disabled.

Last night the display shows that I had 1.98" of rain total, and I believe this is correct.  The rain started around 5:00 PM and ended around 5:00 AM. 

MyAcurite shows a 'rain high' of 1.22" and a total of 0.0". 

WU also shows a total of 0.0", but also shows an accumulation of 1.34" before dropping to 0.0".

Generally the wind speed and temperature indications are the same on the display and on MyAcurite. 

Any suggestions on this?  Thanks!

Photo of verygooddog


  • 8 Posts
  • 4 Reply Likes

Posted 5 months ago

  • 1
Photo of AcuRite Jennifer

AcuRite Jennifer

  • 11801 Posts
  • 536 Reply Likes
Hello Verygooddog,

It looks like you had a missed transmission where the rainfall reset on the 29th.  It looks like at 5pm there was a check in but the next one was not until 5:10pm so It missed the 5:05pm check in which caused the rain to reset to 0. Is this the first time this happened? Please keep an eye on it and let us know if the problem continues.