New sensor Md. 06014 willnot connect to old displays

  • 1
  • Problem
  • Updated 3 months ago
My old 5-in-1 PRO started using up a set of batteries in a month or so.  So I replaced it with a new Md 06014 and a Md 06006 display.   Now these work just fine, but none of my three old displays will pick up the new sensor!  The new are set on 'A'.  I have tried A, B, &C in the old displays.  No luck at all.  It has been over a week and no connection.  
Any ideas on how to get the old displays to connect?
help Cliff
Photo of clifton Liles

clifton Liles

  • 13 Posts
  • 0 Reply Likes

Posted 3 months ago

  • 1
Photo of Ledrak

Ledrak

  • 1458 Posts
  • 327 Reply Likes
Clifton if your old displays are 5 in 1 displays they should work with the new sensor. I'm sure you know how to pair the display with the sensor  remove all power from display set on same channel as sensor and then power up the display it should find the sensor.
Photo of clifton Liles

clifton Liles

  • 13 Posts
  • 0 Reply Likes
I find that pushing the reset causes the display to start searching for a signal.  I did the power reset and one of the three came back.  I'll keep trying with to other two.  
Later: all are back on line.   I think I have a note somewhere that says power cycle dislays.  
Thanks for the reminder
Cliff
(Edited)