model 06058 - barometric pressure does not show

  • 1
  • Question
  • Updated 2 months ago
I have High Resolution Weather Station Display (Model 60058).  The display shows readings for temperature, humidity, wind direction and wind speed.  However, only dashes show for the barometric pressure.  I have tried doing a factory reset, I have tried removing batteries from the outside unit and removing power for the indoor display and reinstalling the batteries to the outdoor sensor and repowering the indoor display and going through the setup process again.  I have waited up to a week and the indoor unit still just shows dashes for the barometric pressure on the indoor unit.  I suspect the issue is with the indoor display unit, as I have another older inside display unit and it does seem to pick up the barometric pressure from the outdoor sensor.  It is just the newer display unit that will not register the barometric pressure.  Any assistance would be greatly appreciated.  Thank you - Alan
Photo of Alan Geddes Jr

Alan Geddes Jr

  • 1 Post
  • 0 Reply Likes

Posted 2 months ago

  • 1
Photo of Ledrak


  • 1506 Posts
  • 335 Reply Likes
Alan the barometric sensor is in the display and not the 5 in 1(rain, temp, humidity, wind speed , and direction only).So if a factory reset did not help it would seem your display has a problem.