Press the “Gear wrench ” button, located on the back of the display, to enter SET MODE. Once in set mode, the preference you are currently setting will blink on the
display. To adjust the currently selected (flashing) item, press and release the “up arrow “ or “down arrow “ buttons (press and HOLD to fast adjust).
To save your adjustments, press and release the “ gear wrench” button again to adjust the next preference. The preference set order is as follows:
TIME ZONE (EST CST MST PST AKT HAT AST)
DST (Daylight Saving Time ON or OFF)*
TEMPERATURE UNITS (oF or oC) Once the C is blinking hit the up or down arrow to change it to F. Once that is done leave it sit there for 10 seconds without touching anything it will exit set mode and the temperature units will be set.
PRESSURE UNITS (inHg or hPa)
WIND UNITS (MPH or KPH)
You will automatically exit SET MODE if no buttons are pressed for 10 seconds.
Enter setup mode at any time by pressing the “gear wrench ” button.
*If you live in an area that observes Daylight Saving Time, DST should be set to ON, even if it is not currently Daylight Saving Time.