Missing sensors after switching to access

  • 1
  • Problem
  • Updated 5 months ago
  • (Edited)
I have a 5-1 sensor, plus indoor display and 2 Temp/Humidity sensors with probe.  Since I switched from smartHub to access only the 5-1 shows up, and it always shows 'red' even though it updates appropriately.

Here is what my access debug page gives:

SIGNAL:433MHZ

#   Type    Id  Last Time (UTC) Signal  Battery
0   5N1 00002970    2018-02-28T00:14:43 4   Low
1   ProIn   00013822    2018-02-28T00:14:46 4   Low
2   ProIn   00012603    2018-02-28T00:14:48 4   Low
5   5N1 00002206    2018-02-28T00:14:47 4   Normal
© Chaney Instrument, Co.

So it clearly sees the 2 sensors (why are there two 5N1's?) but I just can't do anything with them.  I've tried unplugging the access and pulling the batteries from the temp/humd probe sensors but to no avail.

EDIT: They showed up several hours later.  I have two 5-1 stations still listed with slightly different temps which is super weird.

And as a bonus UI PROBLEM on the website:  If you click edit on a sensor a save and cancel button appear.  If you click cancel the edit info goes away but the 'remove' button appears right where the cancel button used to be.  So if the UI is having issues and end up clicking again because the edit area hasn't gone away, it will eventually get around to the other click and then remove your sensor completely.  OOPS!  Put the remove button somewhere not in the same space as the cancel...
Photo of asflkdiejsl

asflkdiejsl

  • 1 Post
  • 0 Reply Likes

Posted 5 months ago

  • 1

Be the first to post a reply!