Access no reporting to Weather Underground

  • 2
  • Question
  • Updated 3 months ago
I just installed an Access on my weather station. It is connected to internet and reports to AcuRite web page. It will not report to Weather Underground. I enabled sharing, put the Station name and password , and pressed the radio button to share with WU. Nothing happens. When I go back to check the Access device, the radio button will be unchecked. Never had a problem reporting thru pc connection.
Photo of Eddie Souther

Eddie Souther

  • 0 Posts
  • 0 Reply Likes

Posted 4 months ago

  • 2
Photo of Tim P

Tim P

  • 3 Posts
  • 0 Reply Likes
I am having the same exact problem.  Just hooked up up my new accurite access today.  I have deleted my sharing to Weather underground (that was working great with pc connect), and re-created, being sure to type in (not copy paste) the WU station id and the WU station key for the password.  no dice so far after 4 hours.  my WU station is KGADAHLO45.
(Edited)
Photo of Christopher T Collins

Christopher T Collins

  • 14 Posts
  • 0 Reply Likes
Same problem here. They claim the problem is on Weather Underground's end, but it worked fine on my previous Access. 
Photo of Tim P

Tim P

  • 3 Posts
  • 0 Reply Likes
Update.  Working now.  Here is what I did.  Disconnected accurite display from my PC.  Made sure PC connect and undertheWX were not running automatically since I suspected there might be some contention between access hub and pc connect when I first set up.  Then I deleted my hub and sensor from myaccurite.  Then did factory reset on the access hub and went through setup process again.  It took about 30 minutes, but now station is reporting to WU. 
Photo of Kim

Kim

  • 2 Posts
  • 0 Reply Likes
I banged my head-on this for a few hours, the key for me was to use my weather underground station id in the 'password' field on the myacurite share weather page. It didn't work if I used my weather underground password!
(Edited)