06044-tx temp display doesn't work , bought 2 of them, one does not show wireless signal on display,, even after reset, waste of $13.00.

  • 1
  • Problem
  • Updated 2 years ago
no wireless signal coming from unit to display
Photo of Michael Walston

Michael Walston

  • 4 Posts
  • 0 Reply Likes
  • disappointed

Posted 2 years ago

  • 1
Photo of AcuRite Jennifer

AcuRite Jennifer

  • 11801 Posts
  • 536 Reply Likes
Hello Michael,

Can you please provide us with the model number of your weather station display? Thank you. Enjoy your day!
Photo of Michael Walston

Michael Walston

  • 4 Posts
  • 0 Reply Likes
06044, actually both of them stopped transmitting more then a few feet.
Photo of Michael Walston

Michael Walston

  • 4 Posts
  • 0 Reply Likes
1536CBI
Photo of AcuRite Jennifer

AcuRite Jennifer

  • 11801 Posts
  • 536 Reply Likes
Hello Michael,

Please remove the batteries from your sensors, and then remove the power from the display for about 2 minutes.  Power the display back up and it should pick up the sensors. Make sure each of the sensors is on a different A-B-C channel. If this does not correct the problem, please let us know. Have a good day!
Photo of Robert Barnes

Robert Barnes

  • 207 Posts
  • 23 Reply Likes
Hmm, so both did connect to the display, but only within a few feet?
Photo of Michael Walston

Michael Walston

  • 4 Posts
  • 0 Reply Likes
did the suggested procedure and it worked for a few days / now the one I have set on "C" reads 64 on the panel display but on the unit itself it only reads 56 and there is no wireless signal display when C comes up on the rotation of the sensor readings. "A" is working good in its location and shows a good signal. Not using "B"
Photo of Robert Barnes

Robert Barnes

  • 207 Posts
  • 23 Reply Likes
Not sure what your display will report when it doesn't get a signal but that's what it sounds like, your 'C' sensor is not successfully sending data. I'd try the reset mini button on the back side and setting the sensor to the 'B' channel. Assuming that doesn't work then get a warranty replacement.
Photo of AcuRite Jennifer

AcuRite Jennifer

  • 11801 Posts
  • 536 Reply Likes
Hello Michael,

We would recommend resetting the display and the sensors. Remove all the power for about 2 minutes.  Put the batteries back in the sensors first, and then the display. Thank you.